Dynamic Power Detailed Presentation

The AMP-F2, developed in collaboration between the Starke Sound team and the Eversolo team, is based on the innovative NS600 module created by the Starke Sound team. It boasts a high sampling rate of up to 600KHz. Simultaneously, it significantly reduces noise and enhances dynamic performance through the newly designed SAPS audio-specific switch power supply. It employs an efficient Class D amplification structure, cou-pled with optimized circuits to maximize audio quality. The AMP-F2 is bridgeable, allowing flexible configura-tion for 2-channel or mono-channel setups when needed.

Vigorous Output Bridged Support

The AMP-F2 is equipped with Starke Sound's NS600 amplifier module, each channel can output a con-stant 250W RMS (42) @ 1% THD +N. When bridged, it can support up to 450W RMS (22) with THD+N still below 1%. This ability to handle extremely low-impedance loads ensures ample energy even in large and challenging speaker setups, particularly during high-dynamic low-frequency outputs.

Accurate Sound Perfect Experience

The NS600 module employs PurePath Ultra-HD technology and advanced integrated feedback design, fea-turing high-speed gate driver error correction functions. This technology achieves ultra-low distortion across the entire audio frequency range, delivering perfect high-end audio quality.

Powerful Power Drive

Utilizing a 600W high-efficiency, low-ripple, low-EMI switch power supply, it delivers consistent and powerful output, extremely low noise, enhancing the overall dy-namic performance of the system.

Environmentally Friendly Low Power Consumption

AMP-F2 has an extremely low standby power (0.5W) and idle power consumption (14W), com-plying with the European Union ErP standards.

Aluminum Body Shielding Design

Complete self-protection and anti-interference design to avoid disturbances from various electrical environments.

One-Touch Activation Seamless Control

The AMP-F2 is equipped with standard 12V TRIGGER IN and TRIGGER OUT function, allowing it to be synchronized with other devices that support the standard TRIGGER interface for power on and off; using the USB to TRIGGER adapter cable provided with the AMP-F2, you can connect the USB Type A interface of the DMP-A6 to the TRIGGER IN of the AMP-F2 to achieve synchronization.

Specifications:

• Output Power:
• 145W RMS at 8 ohms (1% THD)
• 250W RMS at 4 ohms (1% THD)
• 280W RMS at 4 ohms (1% THD, BTL)
• 450W RMS at 2 ohms (1% THD, BTL)
• Input Impedance (XLR): 22KΩ
• Input Sensitivity: 2.7V
• Gain: 21.5dB
• Channel quantity: 2
• Amplifier type: Class D
• Frequency Response: 10Hz-20KHz - 1dB
• Maximum output current per channel: 16.5A/33A(Bridge)
• Output Terminals: 2 pairs beryllium copper binding post custom made by Starke Sound
• Output Impedance: 0.1362(5 Hz t100 kHz)
• Minimum load Impedance: 0.89
• True Balance Circuit: Yes
• Heat: 65 BTU / hr
• Signal-To-Noise Rati(SNR): >110dB, "A" weighted at 4 ohm 250W
• THD: 0.003% 10W at 1KHz
• Input terminals: 2-Channel RCA Input 2-Channel XLR Input
• Input Impedance (RCA): 11KΩ
• Power Consumption:
• Standby: ≤0.5W Idle ≤14W
• Maximum: 900W
• Control Option: 12V trigger input & output
• Size: 270x228x80 (mm)
• Weight: 3.65Kg